Soggy Bread Fly

soggy bread fly 01I've been experimenting with surface/surface film flies for carp lately trying to perfect an easy to tie, solid producer. After about 2 dozen carp and countless missed strikes and break-offs, I think I've finalized my Soggy Bread Carp Fly.

The fly was inspired by a conversation I had with a couple buddies while fishing some local urban ponds about carp and bread. Figuring that a lot of the urban ponds get the duck feeders, I'm sure the carp have keyed into the fact that bread is edible and what it looks like floating in the surface film.

 

So one morning before heading out to the ponds I tied up a couple of experimental flies using some foam and pseudo herl. A very ugly and simple fly, but it looked like a piece of soggy bread floating in the surface film when cast out. I had success the first day out with the fly casting it in front of the carp as they were sucking on the surface. Catching them topwater was a whole new experience, much like dry flies for trout.

I've made a few refinements to the design over the months, but have a solid producer now for urban carp. I've found that even if the carp are not hitting the surface, you can entice them into sucking in your fly by getting it close as they are cruising.

So I present to you, the Soggy Bread Carp Fly.

 

Materials List

Hook: Size 10-12 Dry Fly Hook
Thread: White or Tan thread
Underbody: 1/4" wide Strip of Light Tan Foam
Overbody Tan Pseudo Herl or something "Swimmy" dubbed and picked out

 

Tying Instructions
soggy bread fly step01
soggy bread fly step01
Start by laying down a base of thread on the hook shank, you'll need this to stick the foam to.

soggy bread fly step02

soggy bread fly step02
Tie down your Pseudo Herl or other dubbing. Other things you could use would be dubbed on tan marabou, or some soft dubbing spun loosely. What you are after is that soggy edge of the bread as it bobs in the surface film look

 

soggy bread fly step03

soggy bread fly step03
Cut 2 pieces of foam a little longer than hook shank. Put a drop of glue on your wraps and stick one of the foam pieces on top of the hook, leave enough room to tie off the fly, usually hanging the foam off about a half tail's length.

 

soggy bread fly step04

soggy bread fly step04
Glue the second piece to the first.

 

soggy bread fly step05
soggy bread fly step05
Wrap your thread back and to the front again to make 2 segments in the foam, not too tight, but enough to dimple the foam so the wraps of pseudo herl have somewhere to sit without sliding off on the first cast.
soggy bread fly step06
soggy bread fly step06
Wrap the pseudo herl forward 2 wraps. Secure at the eye of the hook and trim excess.
soggy bread fly step07
soggy bread fly step07
Whip Finish and you're done...

soggy bread fly 02

soggy bread fly 02
Bottom View...

 

soggy bread fly 03

soggy bread fly 03
Top View...

 

The fly when wet should sit in the surface film as the herl and foam fight eachother, one floats the other wants to soak up water and sink. This is a really ugly fly, and I think its fitting for the fish we're chasing with them!

On a side note, I've caught Bass, Bluegill and Tilapia on this fly as well, I wonder what they think it is?

facebook button youtube icon rss icon

azbtf state logo-color